T
Tourniquet
Jungspund
Hallo. Ich habe soeben OpenSuse 10.3 RC1 installiert. Jedoch habe ich das problem, dass GRUB nicht richtig installiert werden kann.
Ich habe ein Raidsystem.
Die Bootpartition befindet sich:
/dev/mapper/isw_cghbeeacdh_ARRAY_part7
dort.
Speicherort des Bootloaders:
Aus Bootpartition, damit ich den Grub-loader ueber den Windows Vista Bootloader, starten kann.
Wenn ich nun, die Einstellungen speichern moechte, kommt folgendes:
Kann mir wer helfen?
Ich habe ein Raidsystem.
Die Bootpartition befindet sich:
/dev/mapper/isw_cghbeeacdh_ARRAY_part7
dort.
Speicherort des Bootloaders:
Aus Bootpartition, damit ich den Grub-loader ueber den Windows Vista Bootloader, starten kann.
Wenn ich nun, die Einstellungen speichern moechte, kommt folgendes:
GNU GRUB version 0.97 (640K lower / 3072K upper memory)
[ Minimal BASH-like line editing is supported. For the first word, TAB
lists possible command completions. Anywhere else TAB lists the possible
completions of a device/filename. ]
grub> setup --stage2=/boot/grub/stage2 (hd0,6) (hd0,6)
Checking if "/boot/grub/stage1" exists... yes
Checking if "/boot/grub/stage2" exists... yes
Checking if "/boot/grub/e2fs_stage1_5" exists... yes
Running "embed /boot/grub/e2fs_stage1_5 (hd0,6)"... failed (this is not fatal)
Running "embed /boot/grub/e2fs_stage1_5 (hd0,6)"... failed (this is not fatal)
Running "install --stage2=/boot/grub/stage2 /boot/grub/stage1 (hd0,6) /boot/grub/stage2 p /boot/grub/menu.lst "... failed
Error 22: No such partition
grub> quit
Kann mir wer helfen?